Motorola G24 Guide - MNTFY, Motorola Notify Indication

Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-53
OK
+TCLCC: 1,0,4,1,0,,"035659801",1 // Call on hold
ATD0502147270; // Dial to another phone
OK
+TCLCC: 2,0,1,1,0,,"0502147270",1
+TCLCC: 2,0,2,1,0,,"0502147270",1
OK
+TCLCC: 2,0,3,1,0,,"0502147270",1
AT+CHLD=3
OK
+TCLCC: 1,0,3,1,1,,"035659801",1
+TCLCC: 2,0,3,1,1,,"0502147270",1
ATH
NO CARRIER
+TCLCC: 1,0,0,1,0,16,"035659801",1
NO CARRIER
OK
+TCLCC: 2,0,0,1,0,16,"0502147270",1// MT Call
+TCLCC: 1,1,6,1,0,,"0502147270",3
RING
RING
ATA
OK
+TCLCC: 1,1,3,1,0,,"0502147270",3
ATH
NO CARRIER
OK
+TCLCC: 1,1,0,1,0,16,"0502147270",3
+MNTFY, Motorola NoTiFY Indication
This command enables/disables unsolicited report of NOTIFY indication arrived from the NW.
The control value resets after power cycle.
Command
Type
Syntax Response/Action Remarks
Set
AT+MNTFY=<cntrl> OK
or:
+CME ERROR: <err>
Set unsolicited reporting
enable/disable.
Unsolicited
Report
+MNTFY:<call-id>,
<desc>
Show unsolicited NOTIFY report.
Read
AT+MNTFY? +MNTFY: <cntrl>
OK
Read the current setting.
Test
AT+MNTFY=? +MNTFY: (List of
supported cntrl>s)
OK
Show list of supported modes.