Motorola G24 Guide - Page 138

Call Control
3-54 AT Commands Reference Manual December 31, 2007
The following table shows the +MNTFY parameters.
Example
AT+MNTFY=?
+MNTFY: (0,1)
OK
AT+MNTFY? // after power cycle
+MNTFY: 0 // disabled
OK
ATD035684349;
OK
OK
ATD035619942;
OK
OK
AT+CLCC
+CLCC: 1,0,1,0,0,"035684349",129,""
+CLCC: 2,0,0,0,0,"035619942",129,""
OK
AT+MNTFY?
+MNTFY: 0
OK // phone call #2 is suspend & resume call,
//no unsolicited report has done.
AT+MNTFY=1// enabled.
OK
AT+MNTFY?
+MNTFY: 1
OK
+MNTFY: 2,0 // phone call #2 is suspend call
+MNTFY: 2,1 // phone call #2 is resumed call
Table 3-25: +MNTFY Parameters
<Parameter> Description
<cntrl> A unique number that identifies a control mode of unsolicited NOTIFY report:
0 - Disable.
1 - Enabled
<call-id> Call identification number:
1-7
<desc> A unique number that identifies a notify description:
0 - Suspend.
1 - Resumed.
2 - Bearer Change.