Motorola G24 Guide - Sending Messages (Using AT+CMGS); Deleting Messages (Using AT+CMGD)

Chapter 4: Using the Commands
December 31, 2007 AT Commands Reference Manual 4-13
Sending Messages (Using AT+CMGS)
Sends an SM from the G24 to the network in TEXT mode, the header parameters will be set
according to CSMP settings. In text mode (+CMGF=1):
AT+CMGS="054565028" //Writing a message to be sent to specified destination address
>This is the message body <CTRL+Z> //<CTRL+Z> ends the prompt text mode and returns to
regular AT command mode
+CMGS: 238 //Message successfully sent. Returns the Message Reference
OK
AT+CMGS="+97254565028",145 //Writing a message to be sent to specified destination address
>message text <CTRL/Z>
+CMGS: 239 //Message successfully sent . Returns the Message Reference
OK
Deleting Messages (Using AT+CMGD)
AT+CMGD=179 //Delete a message using its index
OK
AT+CMGR=179 //The message index is now empty
+CMS ERROR: invalid memory index
Delete a group of messages. Note that deletion of a number of messages may take a short time.
AT+CMGD=1, 1 //Delete all read messages
OK
AT+CMGD= 1,2 //Delete all read and sent messages
OK
AT+CMGD= 1,3 //Delete all read, sent and unsent messages
OK
AT+CMGD= 1,4 //Delete all messages
OK