PC Driver
5-2 AT Commands Reference Manual December 31, 2007
Using WinFAX
To configure the modem in WinFAX, follow the procedure below:
1. Run WinFAX.
2. Select Tools > Program Setup > Modems and Communications Devices > Properties.
3. Set the standard 19200 bps modem to Active.
4. Click Next and select CLASS 1 (Hardware Flow Control) > Next > Finish, Set Default (or
other) > OK.
5. In the Modem and Communications Devices Properties window, click Properties.
6. In General > Communications port, set the COM port to which the modem is connected, and
initialize it to 19200 bps.
Establishing GPRS PDP Context (Using GPRS Manager)
Installing GPRS Manager on a PC
To install and configure GPRS Manager and the Motorola Serial GPRS P2K 57.6 Kbps driver,
follow the procedure below.
1. Run the GPRS Manager setup program.
2. Restart the computer.
Configuring a Dialer Icon
To configure a dialer icon, follow the procedure below.
1. After restarting, verify that G24 is powered up.
2. Run the GPRS Manager Configuration Wizard.
3. In the Wizard, click Next to continue to the next configuration step.
4. Read the instructions thoroughly before moving to the next step.
5. Enter the APN (Access Point Name) provided by your operator.
6. Set the definitions to allow your HTTP/FTP browser to use the G24 as a port to the Internet.
Establishing a Connection
To establish a connection, do the following:
1. Open the GPRS Manager.
2. Double-click the dialer icon to select and activate the provider of your choice (multiple
providers may be displayed in the list).
To Next Page
Loading...
Need help?
General
