Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-135
If after aborting AT+CMGS command execution and before result of operation was
reported by G24, a second AT+CMGS command is executed, then the result of the second
AT+CMGS operation only will be reported by G24.
+CSCB, Cell Broadcast Messages
This command handles the selection of cell broadcast message types and data coding schemes
received by the G24.
Note: The Channel and DCS list is saved to the SIM card.
The maximum number of active channels is SIM dependent.
The AT+CSCB set command is not available when the phone is either in "Emergency
Only" or "No Service" status.
Command Type Syntax Response/Action Remarks
Set
+CSCB=[<mode>
[,<mids>[,<dcss>]
]]
If mode=0 and <mids>
is not specified, then
no channels are
accepted, and the g24
channel/mid list is
cleared.
If mode=1 and <mids>
is not
specified, then
the G24 channel list will
stay as is.
OK
or:
+CME ERROE:<err>
The Set command sets the cell
broadcast message type and data
coding scheme.
Read
+CSCB? +CSCB:
<mode>,<mids>,<dcss>
The Read command displays the
current MID and DCS settings.
Test
+CSCB=? +CSCB: (list of
supported <mode>s)
The Test command displays the
supported values of <mode>.
To Next Page
Loading...
