Email
3-162 AT Commands Reference Manual December 31, 2007
+MEMR, Read Email Message
This AT command is used to display an email message chosen by its <message_id>. <status> of
each message is changed to read status after the message is read for the first time.
The following table shows the +MEMR parameters.
Command
Type
Syntax Response/Action Remarks
Set
A
T+MEMR=<message_id>
+MEMR:<status>,<priorit
y><from>,<to>,<cc>,<bcc
>,<subject>,<date>,<body
>,<name_of_attachments>
OK
or:
+CME ERROR: <err>
Table 3-97: +MEMR Parameters
<Parameter> Description
<message_id> The identity number of the current message.
<status> Status of the message (can be a combination of statuses).
Example:
0 = READ
1 = SENT
2 = UN-READ
3 = UN-SENT
<from> Original message address.
<to> Addresses of intended recipients of current email message. The maximum length of
this parameter is 500 characters.
<cc> Addresses of intended copy recipients of current email message. The maximum
length of this parameter is 500 characters.
<status>
(decimal)
Description
0READ
1SENT
2 UN-(read/sent)
4 Reserved
8 Reserved
16 Reserved
32 Reserved
64 Reserved
128 Reserved
To Next Page
Loading...
Need help?
General
