Call Control
3-52 AT Commands Reference Manual December 31, 2007
The following table shows the +TCLCC parameters.
Example
AT+TCLCC=1
OK
AT+TCLCC?
+TCLCC: 1
OK
ATD035659801; // MO Call
OK
+TCLCC: 1,0,1,1,0,,"035659801",1
+TCLCC: 1,0,2,1,0,,"035659801",1
OK
+TCLCC: 1,0,3,1,0,,"035659801",1
AT+CHLD=2
Table 3-24: +TCLCC Parameters
<Parameter> Description
<state> 0 Disable TCLCC unsolicited indication (Default).
1 Enable TCLCC unsolicited indication.
<idx> Integer type, call identification number.
<dir> 0 Mobile originated call (MO)
1 Mobile terminated call (MT).
<call state> The state of the call
0 Idle
1 Calling (MO call)
2 Connecting (MO call)
3 Active
4 Hold
5 Waiting (MT call)
6 Alerting (MT call)
7 Busy
<mode> Bearer/Teleservice
1 Voice Call
2 Data
3 Fax
9 Unknown
<mpty> Multiparty status
0 Call is not part of a multiparty call.
1 Call is one of multiparty call parties.
<exitcause> See Table 3-197.
<number> Phone number in the format specified by <type>.
Contains a quoted string of up to 32 characters.
<type> 7 bits Phone number display format.
Type of address octet in integer format (refer to GSM 04.08 subclause 10.5.4.7).
To Next Page
Loading...
