AT Commands Alphabetical Summary
A-2 AT Commands Reference Manual December 31, 2007
&G
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
&J
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
&K
This command configures the
RTS/CTS flow control.
Page 3-198
&L
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
&M
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
&P
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
&Q
This command selects the
asynchronous mode, and has no
effect.
Page 3-35
&R
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
&S
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
&T
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
&V This command displays the
current active configuration and
stored user profiles.
Page 3-307
&W This command stores the user
profile.
Page 3-308
&Y This command displays the
default user profile.
Page 3-310
?
This command displays the most
recently updated value stored in
the S-register.
Page 3-281
\A
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
\B
This command is supported for
backward compatibility only, and
has no effect.
Page 3-422
Table A-1: AT Commands (Alphabetical) (Cont.)
AT Command Description Page
To Next Page
Loading...
Need help?
General
