Motorola G24 Guide - Page 401

Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-317
The following table shows the +CIND parameters.
Example
AT+CIND=?
+CIND:
("service",(0,1)),("call",(0,1)),("recmsg",(0,1)),("simav",(0,1)),("Roam",(0-2)),("signal",(0-5)),("smsfull",
(0,1))
OK
AT+CIND?
+CIND: 1,0,0,0,0,5,0
OK
ATD 035684469;
OK
CONNECT
AT+CIND?
+CIND: 1,1,0,0,0,5,0
OK
Table 3-208: +CIND Parameters
<Parameter> Description
<service> 0 Service not available.
1 Service available.
<call> 0 No call in progress.
1 Call in progress.
<recsms> 0 No unread messages.
1 Unread messages exist.
<roam> 0 ME is camped on a home network.
1 ME is roaming on home network.
2 ME is roaming on other network.
<signal> 0 ME has no service.
1 ME has 1 bar of signal strength.
2 ME has 2 bars of signal strength.
3 ME has 3 bars of signal strength.
4 ME has 4 bars of signal strength.
5 ME has 5 bars of signal strength.
<simav> 0 No SIM card available.
1 SIM card is inserted.
<smsfull> 0 SMS storage is not full.
1 SMS storage is full.