Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-123
Note: Reserved bits are ignored.
Table 3-70: <fo> f
or SMS-STATUS-REPORT Message
Bit/s Reference Description
0-1 Mandatory:
Message-Type-Indicator
Parameter describing the message type.
1 0 SMS-STATUS-REPORT (in the
direction SC to MS)
2 Mandatory:
TP-More-Message-To-Send
Parameter indicating whether or not more
messages are waiting to the MS in the
SC.
0 More messages are waiting for the MS
in this SC
1 No more messages are waiting for the
MS in this SC
5 Mandatory:
TP-Status-Report-Qualifier
Parameter indicating whether the
previously submitted TPDU was an
SMS-SUBMIT or an SMS-COMMAND:
0 The SMS-STATUS-REPORT is the
result of a SMS-SUBMIT.
1 The SMS-STATUS-REPORT is the
result of an SMS-COMMAND
6 Optional:
TP-User-Data-Header-Indicator
Parameter indicating whether or not a
status report will be returned to the SME.
0 A status report will not be returned to
the SME
1 A status report will be returned to the
SME
Table 3-71: <TP-PI> for SMS-STATUS-REPORT Message
Bit/s Description
0 0 TP-PID not presence
1 TP-PID not presence
1 0 TP-DCS not presence
1 TP-DCS presence
2 0 TP-UDL not presence
1 TP-UDL presence
3-7 Reserved
To Next Page
Loading...
