SMS
3-138 AT Commands Reference Manual December 31, 2007
The following table shows the +MCSAT parameters.
Table 3-83:
+MCSAT Parameters
<Parameter> Description
<mode> 0 Suppress alert tone
1 Enable alert tone
2 Play alert tone
The default value at power-up is 1.
<dcs_mask> SMS data coding-scheme mask. The format is an 8-bit information parameter. Each
bit contains 0, 1, or X (ASCII character):
0 Condition is met if the arriving SMS includes dcs with 0 in this position
1 Condition is met if the arriving SMS includes dcs with 1 in this position
X or x This bit is ignored from the dcs of the arriving SMS
To Next Page
Loading...
