Motorola G24 Guide - Page 304

Hardware Information
3-220 AT Commands Reference Manual December 31, 2007
Read
AT+MMAD? List of converters and their
monitoring setup values:
+MMAD:
<Converter number>,
<Report>,<Rate>,<Low>,<High><
Num_of_samples>
<Average_calc_duration><Report_
interval><CR><LF>
<Converter number>,
<Report>,<Rate>,<Low>,<High>>
<Num_of_samples>
<Average_calc_duration><Report_
interval>
<CR><LF> <Converter number>,
<Report>,<Rate>,<Low>,<High>>
<Num_of_samples>
<Average_calc_duration><Report_
interval>
<CR><LF> <Converter number>,
<Report>,<Rate>,<Low>,<High>>
<Num_of_samples>
<Average_calc_duration><Report_
interval>
><CR><LF> <Converter number>,
<Report>,<Rate>,<Low>,<High>>
<Num_of_samples>
<Average_calc_duration><Report_
interval>
OK
Read the setting of the A/D
converters.
Test
AT+MMAD=? +MMAD:(range of
<Converter_Number>'s)
,(range of<Report>)
(range of <Rate>),(range of
<Low>),
(range of<High>), (range
of<Num_of_samples>)
,(range of<Average_calc_duration>
),(range of<Report_interval>)
OK
Provides the range of the
parameters.
Command
Type Syntax Response/Action Remarks