Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-297
The following table shows the +CEER parameters.
Table 3-197: +CEER Parameters
<Parameter> Description
<n> 1 Returns numeric response.
2 Returns verbose response.
The default value is 2.
<report> The total number of characters and line terminators (up to 2041) in the information
text.
The text must not contain the sequence 0<CR> or OK<CR>.
Numeric format followed by verbose format:
1 Unassigned or unallocated number
3 No route to destination
6 Channel unacceptable
8 Operator determined barring
16 Normal call clearing
17 User busy
18 No user responding
19 User alerting, no answer
21 Call rejected
22 Number changed
26 Non selected user clearing
27 Destination out of order
28 Invalid number format (incomplete number)
29 Facility rejected
30 Response to STATUS ENQUIRY
31 Normal, unspecified
34 No circuit/channel available
38 Network out of order
41 Temporary failure
42 Switching equipment congestion
43 Access information discarded
44 Requested circuit/channel not available
To Next Page
Loading...
Need help?
General
