Chapter 3: AT Commands Reference
December 31, 2007 AT Commands Reference Manual 3-353
The following table shows the +CGEQNEG command parameters.
Table 3-226:
+CGEQNEG Command Parameters
<Parameter> Description
<cid> Numeric parameter which specifies a particular PDP
context definition (see +CGDCONT and
+CGDSCONT commands).
<Traffic class> Numeric parameter that indicates the type of
application for which the EDGE bearer service is
optimized.
0 - conversational
1 - streaming
2 - interactive
3 - background
4 - subscribed value
If the Traffic class is specified as conversational or
streaming, then the Guaranteed and Maximum bit rate
parameters should also be provided.
<Maximum Bit-rate UL> Numeric parameter that indicates the maximum number
of kbits/s delivered to EDGE (up-link traffic) at a SAP.
As an example a bit rate of 32kbit/s would be specified
as '32' (e.g. AT+CGEQREQ=…,32, …). If the
parameter is set to '0' the subscribed value will be
requested This parameter should be provided if the
Traffic class is specified as conversational or streaming.
<<Maximum Bit-rate DL> Numeric parameter that indicates the maximum number
of kbits/s delivered by EDGE (down-link traffic) at a
SAP. As an example a bit rate of 32kbit/s would be
specified as '32' (e.g. AT+CGEQREQ=…,32, …). If the
parameter is set to '0' the subscribed value will be
requested. This parameter should be provided if the
Traffic class is specified as conversational or streaming.
<Guaranteed Bit-rate UL> Numeric parameter that indicates the guaranteed
number of kbits/s delivered to EDGE (up-link traffic) at
a SAP (provided that there is data to deliver). As an
example a bit rate of 32kbit/s would be specified as '32'
(e.g. AT+CGEQREQ=…,32, …). If the parameter is set
to '0' the subscribed value will be requested. This
parameter should be provided if the Traffic class is
specified as conversational or streaming.
<Guaranteed Bit-rate DL> Numeric parameter that indicates the guaranteed
number of kbits/s delivered to EDGE (down-link
traffic) at a SAP (provided that there is data to deliver).
As an example a bit rate of 32kbit/s would be specified
as '32' (e.g. AT+CGEQREQ=…,32, …). If the
parameter is set to '0' the subscribed value will be
requested. This parameter should be provided if the
Traffic class is specified as conversational or streaming.
To Next Page
Loading...
