Motorola G24 Guide User Manual

Chapter 1: Product Features
December 31, 2007 AT Commands Reference Manual 1-27
+MCWAKE This command displays reports on the status of the GPRS/GSM
coverage.
Page 3-202
+MGGIND This command configures the service indicator on pin 49 of the 70
pin connector to be GPRS or GSM.
Page 3-203
+CFUN This command shuts down the phone functionality of smart phones
and PDAs with phone capabilities.
Page 3-204
+ICF This command determines the local serial port start/stop
(asynchronous) character framing used by the DCE when accepting
DTE commands and transmitting information text and result codes.
Page 3-205
S97 This command indicates whether an antenna is physically connected
to the G24 RF connector.
Page 3-206
+MRST This command enables customer software to perform a hard reset to
the G24 unit.
Page 3-207
+TWUS This command is used to set the wakeup reason(s).
Page 3-207
+TWUR This command is used to query the wakeup reason(s).
Page 3-209
+TASW This command controls the antenna switch mechanism.
Page 3-209
+TADIAG This command queries actual ADC values of the antennas.
Page 3-210
READY This unsolicited notification indicates UART is ready.
Page 3-211
+MPSU This command defines the functionality of the second physical
UART.
Page 3-211
+MIOC
This command defines the G24 8 GPIO pins data value. Page 3-213
+MIOD
This command defines the G24 8 GPIO pins configuration. Page 3-217
+MMAD This command reads and monitors digital value from a specified
ADC.
Page 3-219
+MPCMC This command defines whether the PCM clock is generated
continuously or not, when module is in digital audio mode.
Page 3-226
+MVREF This command defines the behavior of Vref regulator.
Page 3-227
Audio
General Audio Setup Commands
+CRTT This command plays one cycle of a ring tone, stops the cycle in the
middle, and sets the ring tone to be used.
Page 3-247
+VTD This command handles the selection of tone duration.
Page 3-250
+VTS This command transmits a string of DTMF tones when a voice call
is active.
Page 3-251
+CALM This command handles the selection of the G24’s alert sound mode.
Page 3-245
+MDMIC This command enables/disables the setting of microphone gain
values by +MMICG in digital audio mode.
Page 3-246
+MMICG This command handles the selection of microphone gain values.
Page 3-246
Table 1-1: AT Commands (Cont.)
AT Command Description Page

Motorola G24 Guide Specifications

General

Brand	Motorola
Model	G24 Guide
Category	Telephone Accessories
Language	English