Motorola G24 Guide - Page 81

Chapter 2: Introduction to AT Commands
December 31, 2007 AT Commands Reference Manual 2-13
+MEML This command is used to list Email messages.
Page 3-159
+MEMSE This command is used to send an Email message.
Page 3-156
+MEMR This command is used to read an Email message.
Page 3-162
+MEMW This command is used to write or update an Email message.
Page 3-165
+MFIC
This command instructs the G24 to query or set Filtering
Incoming Calls parameters.
Page 3-40
+MFOTAABOR
T
Aborts the DM session.
Page 3-270
+MFOTACNFG This command enables setting the DM session as
Automatic/Non-Automatic (i.e. Transparent/Non-Transparent).
Page 3-266
+MFOTAIND This command sends Unsolicited FOTA indications toward DTE.
Page 3-271
+MFOTAINSTL Installs the updated package.
Page 3-270
+MFOTAREQ This command sends FOTA requests toward DTE.
Page 3-268
+MFOTARSP This command is used to send response to +MFOTAREQ reports.
Page 3-269
+MFOTAWSCF
G
This command sets the Web-Session default entry.
Page 3-265
+MGEER This command returns the PDP context activation reject cause.
Page 3-299
+MGGIND This command configures the service indicator on pin 49 of the 70
pin connector to be GPRS or GSM.
Page 3-203
+MIOC
This command defines the G24 8 GPIO pins data value. Page 3-213
+MIOD
This command defines the G24 8 GPIO pins configuration. Page 3-217
+MIPCFF This command allows configuring the incoming TCP connection
filtering feature parameters, such as list of allowed IP addresses or
disabling/enabling the filtering.
Page 3-417
+MIPCONF This command allows to configure TCP stack parameters, such as
retransmissions number, upper and bottom limits of retransmission
timeout, close delay.
Page 3-403
+MIPCSC This AT command is used to configure the SSL feature behavior in
case of non - fatal alerts.
Page 3-414
+MIPDATA
This unsolicited event is sent to the terminal indicating a
data comes from Network when G24 is in pseudo-command
mode.
Page 3-401
+MIPODM This command causes the G24 module to initialize a new socket in
Online Data Mode and open a connection with a remote side.
Page 3-389
+MMAD This command reads and monitors digital value from a specified
ADC.
Page 3-219
+MPSU This command defines the functionality of the second physical
UART.
Page 3-211
Table 2-1: Core AT Commands (Cont.)
AT Command Description Page