Chapter 2: Introduction to AT Commands
December 31, 2007 AT Commands Reference Manual 2-15
O This command returns a phone to the Online Data mode and issues
a CONNECT or CONNECT <text> result code.
Page 3-34
P This command is supported for backward compatibility only, and
has no effect.
Page 3-422
Q This command determines whether to output/suppress the result
codes.
Page 3-274
READY This unsolicited notification indicates UART is ready.
Page 3-211
Sn This command reads/writes values of the S-registers, and includes
registers 1-49, 94, 96 (Audio) and 102 (Sleep mode).
Page 3-277
T This command is supported for backward compatibility only, and
has no effect.
Page 3-422
V This command determines the response format of the data adapter
and the contents of the header and trailer transmitted with the result
codes and information responses.
Page 3-273
X This command defines the data adaptor response set, and the
CONNECT result code format.
Page 3-276
Y This command is supported for backward compatibility only, and
has no effect.
Page 3-422
Z This command resets the default configuration.
Page 3-282
Table 2-1: Core AT Commands (Cont.)
AT Command Description Page
To Next Page
Loading...
