NEC NEAX 2000 - Page 428

REMOTE ACCESS TO SYSTEM
– 408 –
A2397-10
(2) With AP01 card
DESCRIPTION DATA
Assign the AP number to the AP01 card.
NOTE: The AP number must match the
SENSE switch setting on the
AP01 card.
•
(1)
(2)
Y=0
04-15: AP No.
07
Designate the processor checking the ID
code for Remote Access to System as
AP01 card.
(1)
(2)
217
1 : AP01 card
Assign the ring cadence on a Remote Ac-
cess to System call.
(1)
(2)
180
0 : As per CM08>392
1 : As per CM35 Y=33
Assign the terminating system in Day
Mode, Night Mode, Mode A and Mode B
for incoming C.O. Calls to required trunks.
•
•
•
•
(1)
(2)
Y=02 Day Mode
Y=03 Night Mode
Y=40 Mode A
Y=41 Mode B
000-255: Trunk No.
16: Remote Access to System
Specify the handling of busy/not available
Remote Access to System destination in
Day or Night Mode when calling an inter-
nal station.
•
•
(1)
(2)
Y=30 Handling of busy/not available
Remote Access to System desti-
nation in Day Mode
Y=31 Handling of busy/not available
Remote Access to System desti-
nation in Night Mode
000-255: Trunk No.
00 : C.O. Line release
01 : Forwarded to TAS
03 : Forwarded to Attendant Console
04 : Forwarded to DIT station
assigned by CM30 Y=04, 05
06 : DT connection for redial
08 : C.O. line release
15 : C.O. line release
CM08
CM30
START
CM05
A
INITIAL