REMOTE ACCESS TO SYSTEM
– 409 –
A2397-10
NOTE 1: Approximately 1,000 Remote Access to System codes including Authorization Codes
and Forced Account Codes can be defined. The number of codes varies with the num-
ber of digits assigned to each code. For details, refer to APPENDIX D “FEATURES
AND SPECIFICATIONS”.
page D1
NOTE 2: When deleting all ID codes stored in the AP01 card at one time, do the following oper-
ation:
DESCRIPTION DATA
Assign the release signal condition to a
incoming trunk route assigned by CM30
Y=00.
•
(1)
(2)
Y=05
00-63: Trunk Route No.
1 : Release signal arrives
Specify the combination of trunk routes al-
lowing the Trunk to Trunk connection.
•
(1)
(2)
Y=0
XX ZZ
XX: 00-63: Incoming Trunk Route
ZZ : 00-63: Outgoing Trunk Route
0 : Allowed
1 : Restricted
Specify the maximum number of digits for
Remote Access to System.
(1)
(2)
13
01-10 : 1 digit-10 digits
NONE : 10 digits
If Check Code is provided, the maximum
No. of digits is limited to 8.
Set the ID Code and its temporary Service
Class used for Remote Access to System.
For details of the programming, refer to
AUTHORIZATION CODE (with AP01
card).
page 52
•
•
•
•
Y=0
Y=1
Y=3
Y=A
CM36
CM42
END
CM35
A
CMD5
ST
EXE
+ + +
+
D60
DE
++
DE
0000 CCC
To Next Page
Loading...
