NEC NEAX 2000 - Page 430

REMOTE ACCESS TO SYSTEM
– 410 –
A2397-10
To access the Digital Announcement Trunk (DAT) card via Remote Access to System, add the
following programming.
DESCRIPTION DATA
Assign Digital Announcement Trunk card
number to the required LEN.
NOTE: The Digital Announcement Trunk
card number must be assigned
to the first LEN (Level 0), the
third LEN (Level 2), the fifth LEN
(Level 4) and the seventh LEN
(Level 6) of each LT slot.
(1)
(2)
000-763: LEN
EB002-EB127: Digital Announcement
Trunk Card No.
For PIM0/1: EB002-EB031
For PIM2/3: EB032-EB063
For PIM4/5: EB064-EB095
For PIM6/7: EB096-EB127
NOTE: EB000 and EB001 are
dedicated to built-in Digital
Announcement Trunk of the
MP card.
Assign the Service Restriction Class A for
Digital Announcement Trunk access to the
required ID Code Pattern number.
•
(1)
(2)
Y=12
0000-2999: ID Code Pattern No.
assigned by CM2A Y=00-
09
00-15 : Service Restriction Class A
Allow Digital Announcement Trunk access
in the Service Restriction Class A as-
signed by CM2A Y=12.
•
(1)
(2)
Y=33
00-15: Service Restriction Class A
assigned by CM2A Y=12
1 : Allow
Assign the Service Restriction Class A for
Digital Announcement Trunk access to the
required ID Code, when providing Remote
Access to System with an Application Pro-
cessor (AP01).
•
(1)
(2)
Y=3
X-X...X: ID Code (Max Number of digits
specified by CM42>13)
201 XX 0000
XX: 00-15 : Service Restriction Class
A
Allow Digital Announcement Trunk access
in the Service Restriction Class A as-
signed by CMD5 Y=3.
•
(1)
(2)
Y=33
00-15: Service Restriction Class A as-
signed by CMD5 Y=3
1 : Allow
CM2A
CM15
CMD5
START
CM10
A
CM15