ANNOUNCEMENT SERVICE
– 25 –
A2018-10
NOTE: Announcement Service can be used to provide a voice message when an incoming
C.O. line/Tie line call has been transferred and encounters a busy or no answer condi-
tion. After the voice message is given, normal call processing continues.
• This application can be programmed on a tenant basis.
• Only one (1) message of up to the following seconds can be recorded on an individ-
ual Digital Announcement Trunk Card.
Built-in DAT on MP: 120 sec.
4DAT card: 120 sec.
•
In this application, a minimum of two Digital Announcement Trunk Circuits are need-
ed, one for busy condition, and one for no answer.
• More than one Digital Announcement Trunk Circuit can be used, depending on traffic
conditions.
• System programming can be set to, wait until circuit(s) become free or immediately
follow preprogrammed normal call handling, if a busy condition is encountered.
•
Digital Announcement Trunk Circuits can be shared among tenants.
• This feature does not function on Attendant transferred calls.
DESCRIPTION DATA
Assign the function for each Digital An-
nouncement Trunk card.
•
(1)
(2)
Y=00
000-001: Built-in DAT on MP card
002-127: Digital Announcement Trunk
Card No. (EB002-EB127) as-
signed by CM10
06XX: No Answer
XX : 00-63: Message No.
07XX: Busy
XX : 00-63: Message No.
•
•
(1)
(2)
Y=06 No Answer
Y=07 Busy
XX: 00-63: Tenant No. of transferring
station
XX: 00-63: Message No. assigned by
Y=00
To record, replay and delete a message,
assign the respective Digital Announce-
ment Trunk access code.
•
(1)
(2)
Y=0-3 Number Plan Group 0-3
X-XXXX: Access Code
A100: Record
A101: Replay
A102: Delete
CM20
END
CM49
A
To Next Page
Loading...
