SPEED CALLING-ONE TOUCH-D
term
– 445 –
A2437-10
(2) To provide the One Touch key to send “Hooking Signal + Called Number” to a Centrex, set
the following data in addition to the programming (1).
(3) To provide the One touch key to send “Called Number + DTMF Signal” for such as VMS
operation, set the following data in addition to the programming (1), when the called number
includes a trunk access code. If the called number includes no trunk access code, this data
is not required.
HARDWARE REQUIRED
D
term
with One Touch key and DLC card
DESCRIPTION DATA
Assign the access code for sending of a
Hooking signal to a Centrex.
Maximum of two digits are available.
•
(1)
(2)
Y=0-3
X-XXXX: Access code
A158: Hooking signal to a Centrex
Assign a RECALL key on the D
term
.
RECALL key is used to return to a former
line.
•
(1)
(2)
Y=00
My Line No. + + Key No. (90)
F1015: RECALL
Provide the Centrex trunk route with
Centrex function.
•
(1)
(2)
Y=86
00-63: Trunk Route No.
0: Centrex
DESCRIPTION DATA
Specify whether to set consecutive dialing
“*#” as a delimiter between the called num-
ber and the DTMF signal.
(1)
(2)
448
0 : *# set as dialed digit
1 : Delimiter between called number
and DTMF signal
CM90
CM35
START
CM20
END
,
START
CM08
END
To Next Page
Loading...
