NEC NEAX 2000 - Page 481

SPLIT CALL FORWARDING-BUSY LINE
– 461 –
A2452-10
DESCRIPTION DATA
To apply this feature to incoming calls, set
the trunk route combinations for Tandem
Connection.
•
(1)
(2)
Y=05
00-63: Trunk Route No.
1 : Release Signal arrives
•
(1)
(2)
Y=0
Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35
Y=05
0: Allow
Specify the setting method for Call For-
warding Busy Line-Outside.
(1)
(2)
222
0 : This feature is set when the station
goes on hook/when receiving Ser-
vice Set Tone (ORT time out)
1 : This feature is set when receiving
Service Set Tone (ORT time out)
Allow or restrict the ability to set Call For-
warding-Busy Line for a station with Do
Not Disturb set.
(1)
(2)
240
0 : Allow
1 : Restrict
Assign whether or not an extension can
set Split Call Forwarding-Busy Line-Out-
side by entering only a trunk access code.
(1)
(2)
386
0 : Restricted
1 : Allow
Assign whether or not the system should
check the trunk restriction class of the for-
warded station during a Call Forwarding-
Busy Line-Outside.
(1)
(2)
387
0 : Follow trunk restriction class
1 : No check
Assign Call Forwarding-Busy Line keys to
the D
term
s, as required.
•
(1)
(2)
Y=00
My Line No. + + Key No.
F0014: Call Forwarding-Busy Line Set/
Cancel
For setting the same key as Call Forward-
ing-Don’t Answer.
(2) F0012: Set/Cancel
Assign Split Call Forwarding-Busy Line
keys to the D
term
s, as required.
(1)
(2)
My Line No. + + Key No.
F0A82: Split Call Forwarding-Busy
Line/-Don’t Answer Set/Cancel
CM08
CM35
A
CM36
B
,
,