STATION MESSAGE DETAIL RECORDING (SMDR)
PROGRAMMING
SMDR with AP00 Programming
– 491 –
A2486-10
DESCRIPTION DATA
If the masking of Authorization Codes sent
to the SMDR terminal is required, assign
the desired value to be added to the Au-
thorization Code dialed.
For example:
To mask the Authorization Code “1234” by
adding “5” to all digits:
(1) 160 (1) 162
(2) 5 (2) 5
(1) 161 (1) 163
(2) 5 (2) 5
With this assignment, “6789” is sent to
SMDR Terminal.
(1)
(2)
160-175: Designation of digit to be
masked: 1st digit-16th digit
0 : No masking
1-11: Value to be added to the desig-
nated digit of Authorization Code.
12 : Masking with “X”
Assign maximum number of Call Record
for SMDR which is set to “4” by
CMD001>80/100/120/140.
NOTE 1: When the data is set to 1-27000,
external alarm of memory over-
flow is available, if CM44, 2nd
data=3001 is assigned.
(1)
(2)
29
0 : Not Record
1-27000: 1 call-27000 calls
NOTE 2: The amount of call record number set by CMD003>23, 24, 25, 26, 28, 29, 30 must
not exceed the following number.
CMD003
CMD001
D
E
1st digit
2nd digit
3rd digit
4th digit
Amount of Call Record number of CMD003 1st data 23, 24, 25, 26, 28, 29, 30
No EXPMEM on AP00 is provided EXPMEM on AP00 is provided
When CMD001>179
is set to 0
(Not a center office of
Centralized Billing-CCIS)
When CMD001>179
is set to other than 0
(center office of Central-
ized Billing-CCIS)
When CMD003>28
is set to 0
(Call Record for CIS is not
provided)
When CMD003>28
is set to other than 0
(Call Record for CIS is
provided)
1600 800 27000 26000
To Next Page
Loading...
