NEC NEAX 2000 - Page 514

STATION MESSAGE DETAIL RECORDING (SMDR)
PROGRAMMING
SMDR with AP00 Programming
– 494 –
A2486-10
DESCRIPTION DATA
Specify SMDR service for Tie Line calls, if
needed.
(1)
(2)
XX 21: Sending of billing information of
Tie Line outgoing calls to the
SMDR terminal set to “4” by
CMD001>80/100/120/140
XX : Service Class No. assigned by
CMD015
0 : Not sent
1 : To send
(1)
(2)
XX 22: Sending of billing information of
Tie Line outgoing calls to the
SMDR terminal set to “5” by
CMD001>80/100/120/140
XX : Service Class No. assigned by
CMD015
0 : Not sent
1 : To send
Assign the Development Table number to
outgoing trunk routes.
(1)
(2)
00-63: Trunk Route No.
000 -511: Development Table No.
Specify the call information sending func-
tion to each dialed number.
(1)
(2)
XXX Y
XXX: 000-511: Call Development Table
No. assigned by CMD026
Y : 0-9, A (*), B (#): Dialed Digit
XXX3 : Refer to next digit assignment
(XXX: 000-511: Next Develop-
ment Table No.)
9 : Send to SMDR
Assign a Call Development Table number
to each outgoing trunk route.
(1)
(2)
00-63: Trunk Route No.
0 -127: Call Development Table
No.
Assign the Type of Call for each dialed digit
(0-9, A, B) on the basis of each Call Devel-
opment Table number assigned by
CMD033.
(1)
(2)
XXX Y
XXX: 000-127: Call Development Table
No. assigned by CMD033
Y : 0-9, A (*), B (#): Dialed Digit
11 : Local call
21 : Toll call
31 : International call
91 : Tie Line call
CMD016
G
CMD026
CMD033
CMD034
H
CMD027