NEC NEAX 2000 - Page 513

STATION MESSAGE DETAIL RECORDING (SMDR)
PROGRAMMING
SMDR with AP00 Programming
– 493 –
A2486-10
DESCRIPTION DATA
The external alarm driver function for the
SMDR buffer overflow.
(1)
(2)
XX Y
XX : 00-31: DK Card No. assigned by
CM10 (E800-E831)
Y : 0-3: Circuit No.
313: MP built-in External Equipment In-
terface
3001: When CMD001>80/100/120/140
is set to “4”
3002: When CMD001>80/100/120/140
is set to “5”
When sending the tenant information (00-
63) to the SMDR terminal, assign a Group
number to each station or Attendant Con-
sole.
(1)
(2)
X-XXXX: Station No.
000-063: Group No.
(1)
(2)
00-07: ATTCON No. 0-7
000-063: Group No.
Assign the Charging Station Class number
to each station number.
(1)
(2)
X-XXXX: Station No.
00 -15: Station Class No.
Specify the direction for sending of billing
information on C.O. outgoing calls.
(1)
(2)
XX 16: Sending of billing information of
C.O. outgoing calls to the PMS/
SMDR terminal set to “4” by
CMD001>80/100/120/140
XX : Service Class No. assigned by
CMD015
0 : Not sent
1 : To send
(1)
(2)
XX 17: Sending of billing information of
C.O. outgoing calls to the
SMDR terminal set to “5” by
CMD001>80/100/120/140
XX : Service Class No. assigned by
CMD015
0 : Not sent
1 : To send
CM44
F
G
CMD012
CMD016
CMD015