NEC NEAX 2000 - Page 546

TOLL RESTRICTION-TOTAL DIGIT COUNT
– 526 –
A2523-10
HARDWARE REQUIRED
COT card
DESCRIPTION DATA
According to the characteristics of each
C.O. line, assign the data for DP/DTMF
Sender to each Route.
For details of the command, refer to
“COMMAND MANUAL”.
Specify the timing for ORT Timeout on
Outgoing C.O. Call.
•
•
•
•
•
•
•
•
•
(1)
(2)
Y=20 Sender Start Condition
Y=21 Sender Prepause Timing
Y=23 DP-Inter Digital Pause
Y=24 DTMF-Inter Digital Pause
Y=25 DP-Make Ratio
Y=26 DTMF Signal Width
Y=45 DP Sender Release Timing
Y=46 DTMF Sender Release Timing
Y=0
27
03-14: 3 sec.-14 sec.
(1 sec. increments)
If no data is set, the default setting is 7 sec.
Assign the access code to each route. •
(1)
(2)
Y=0-3 Numbering Plan Group 0-3
X-XXXX: Access Code
100-163: Trunk Route No. 00-63
Assign the maximum number of sending
digits dialed after C.O. access code.
•
(1)
(2)
Y=0-7 Area Code Analysis Group
Area/Office Code (1-8 digits)
Maximum number of sending digits
(1-24 digits)
NOTE: For unassigned office code by
this command, the maximum
number of sending digits is
automatically set to “24”.
CM41
CM20
CM85
END
CM35
B