TRUNK TO TRUNK CONNECTION
– 542 –
A2536-10
To provide the AMP trunk for Trunk to Trunk Connection:
DESCRIPTION DATA
Assign the Card number of the AMP trunk
(AMP card).
NOTE: The AMP card number must be
assigned to both of the first LEN
(Level 0) and the third LEN (Lev-
el 2) of each slot.
(1)
(2)
000-763: LEN
Card No. of AMP trunk
For PIM0/1: C100-C115
For PIM2/3: C116-C131
For PIM4/5: C132-C147
For PIM6/7: C148-C163
Assign the AMP patterns to each combi-
nation of the trunk routes.
•
(1)
(2)
Y=00
XX ZZ
XX: 00-63: Incoming trunk route
ZZ: 00-63: Outgoing trunk route
00-14: AMP pattern No. 00-14
15 : Not use the AMP trunk
Assign the gain value of each AMP pat-
tern.
•
(1)
(2)
Y=01
00-14: AMP pattern No. 00-14
X Z
X: AGC (Automatic Gain Control)
0 : 0 dBr
1 : +4 dBr
2 : –4 dBr
3 : Through
(assigned by Fixed Gain)
Z: Fixed Gain
0 : 12 dB
1 : 8 dB
2 : 4 dB
3 : 0 dB
Assign the Echo Canceller function to
each AMP pattern.
•
(1)
(2)
Y=02
00-14: AMP pattern No. 00-14
0 : Through
1 : Normal
Assign the Gain Controller of Echo Can-
celler to each AMP pattern.
•
(1)
(2)
Y=03
00-14: AMP pattern No. 00-14
0 : ON
1 : OFF
CM38
START
CM10
A
To Next Page
Loading...
