UNIFORM CALL DISTRIBUTION (UCD)
– 551 –
A2546-10
To provide the external Indicator for Overflowed UCD Call:
DESCRIPTION DATA
Assign the incoming call to queuing mode
when all UCD stations are busy.
(1)
(2)
212
1 : Queuing
Specify the maximum number of queuing
in each UCD group for controlling external
indicator.
(1)
(2)
15
01-99: Number of queuing in each UCD
group
If no data is set, the default setting is 01.
NOTE: Depending on the number of
queuing station/trunk, lamp indi-
cation pattern on external indica-
tor is different as shown below:
N=Number of queuing station/trunk
Assign the DK card to the required LEN.
NOTE: The DK card number must be as-
signed to the first LEN (Level 0)
and the third LEN (Level 2) of
each LT slot.
(1)
(2)
000-763: LEN
E800-E831: DK Card No.
For PIM0/1: E800-E807
For PIM2/3: E808-E815
For PIM4/5: E816-E823
For PIM6/7: E824-E831
NOTE: Circuit No. 3 of E831 is used
for built-in External Equip-
ment Interface on MP card by
setting CM44.
CM42
CM10
START
CM08
A
CONDITIONS LAMP INDICATION
2nd Data=01
Lamp on irrespective of number of queuing station/trunk (For the indication
pattern, see CM59.)
N<2nd Data
(2nd Data≠01)
Lamp off
2nd Data≤N
(2nd Data≠01)
Lamp on (For the indication pattern, see CM59.)
To Next Page
Loading...
