NEC NEAX 2000 Programming Manual

FEATURES FOR AUSTRALIA ONLY
MFC-INCOMING CALL
– 589 –
A2580-10
DESCRIPTION DATA
Assign the Forward GII signal to terminate
a call to Attendant Console, if required.
NOTE: CM31 Y=9 is effective only when
CM08>020 is assigned to 1.
•
(1)
(2)
Y=9
01-15: Forward GII-1 through Forward
GII-15
00 : Terminating to Attendant Console
NOTE
15 : Terminating to station
Select whether a call is terminated to At-
tendant Console by receiving Forward GII
signal or not.
(1)
(2)
020
0 : Not allowed
1 : To allow
Assign the meaning of sending Backward
GB signal when terminating to Attendant
Console.
(1)
(2)
470
0 : Called station control
1 : Called station idle (charge)
Assign the meaning of sending Backward
GB signal when terminating by Tandem
Connection or converting received digits.
(1)
(2)
471
0 : Called station control
1 : Called station idle (charge)
Select whether to request ANI signal to
PSTN or not.
(1)
(2)
472
0 : Available
1 : Not available
Specify the kind of idle status of called sta-
tion on DID call.
•
(1)
(2)
Y=11
X-XXXXXXXX: Station No.
0 : Called Station idle (No Charge)
1 : Called Station Control (Charge)
2 : Called Station idle (Charge)
3 : Called Station idle (Charge)
Assign the meaning of sending Backward
signal when address is completed.
•
(1)
(2)
Y=48
00-63: Trunk Route No.
0 : Set up speech condition without
waiting Forward GII
1 : Waiting Forward GII
Assign no sending of 2nd Dial Tone on call
termination.
•
(1)
(2)
Y=10
00-63: Trunk Route No.
0: 2nd DT is not sent
CM08
CM12
CM35
CM31
A
END

NEC NEAX 2000 Specifications

General

Brand	NEC
Model	NEAX 2000
Category	Server
Language	English