FEATURES FOR AUSTRALIA ONLY
MFC-INCOMING CALL
– 588 –
A2580-10
(2) DID Data Assignment
DESCRIPTION DATA
Assign the MFC Signaling to required DID
trunk route.
•
(1)
(2)
Y=37
00-63: Trunk Route No.
0: Available
Assign the number of received digits of
ANI signal from PSTN.
NOTE: CM31 Y=1>3 setting is required
when CM08>472 is assigned to
0.
•
(1)
(2)
Y=1
3
01-31: 1 digit-31 digits
NONE
Assign the sending Backward GA signals
depending on the specification of each
country.
•
(1)
(2)
Y=3: Backward GA
00-15
01-15
NONE
Assign the sending Backward GB signals
depending on the specification of each
country.
•
(1)
(2)
Y=4: Backward GB
00-15
01-15
NONE
Assign the Pulse Form/Pulse Type-1/
Pulse Type-2 signals.
NOTE 1: For details of Pulse Form/Pulse
Type-1/Pulse Type-2 signals, re-
fer to the Command Manual.
•
(1)
(2)
Y=A
05: Pulse Form signal
06: Pulse Type-1 signal
07: Pulse Type-2 signal
01-15
NONE
NOTE 2:
Refer to the “MFC Data
Assignment Table for Austra-
lia” on the following pages.
START
CM35
A
CM31
INITIAL
INITIAL
NOTE 2
INITIAL
INITIAL
To Next Page
Loading...
