NEC NEAX 2000 - Page 616

FEATURES FOR OTHER COUNTRIES ONLY
CALLER ID CLASS
– 596 –
A2594-10
(2) CALLER ID Receiver Assignment
DESCRIPTION DATA
Provide the system with MFC Signaling. (1)
(2)
52: MFC Signaling
0 : To provide
Assign an AP number to the CIR (CALLER
ID Receiver) trunk.
•
(1)
(2)
Y=0
04-15: AP No.
08: CIR trunk (PN-4RSTC)
The AP number must match the SENSE
switch setting on the CIR trunk.
Assign the trunk number to each circuit of
the CIR trunk.
•
(1)
(2)
Y=04
00-15: Trunk No.
XX Z
XX: AP No. assigned by CM05
Z : 0-3: Circuit No.
Assign requesting CALLER ID signal from
network when an incoming call termi-
nates.
(1)
(2)
472: Request for ANI/CALLER ID sig-
nal
0: Available
Assign the sending method of calling num-
ber from the network, to the AP number
assigned by CM05.
•
(1)
(2)
Y=07
04-15: AP No.
0: CALLER ID (CLASS SM)
Assign the number of digits of the calling
number sent from the network.
•
(1)
(2)
Y=1
3: Number of Digits from Network
01-31 : 1 digits-31 digits
NONE : No data
Assign the CALLER ID Receiver to each
AP number (0-3) of the CIR trunk.
AP number 0-3 correspond to the AP num-
ber (04-15) assigned by CM05.
•
(1)
(2)
Y=2
0: AP No. 0=AP No. X
1: AP No. 1=AP No. Y
2: AP No. 2=AP No. Z
3: AP No. 3=AP No. W
X
< Y < Z < W
3 : All circuits are assigned as receiv-
er
CM08
CMAA
CM31
START
END
CM09
CM05
CM06
INITIAL
INITIAL
INITIAL
INITIAL
INITIAL