NEC NEAX 2000 - Page 617

FEATURES FOR OTHER COUNTRIES ONLY
CALLER ID CLASS
– 597 –
A2594-10
(3) Memory Clear for CIR Trunk (PN-4RSTC Card)
Clearing all data in memory for calling number development is necessary before assigning
the calling number development data by CMDC and CMDB.
NOTE: Before memory clear, set the SW1-1 to SW1-4 on the CIR trunk to all ON (Make-busy)
and after memory clear, restore them to OFF.
If required, clear the partial memory using the commands shown below.
NOTE: Before memory clear, set the SW1-1 to SW1-4 on the CIR trunk to all ON (Make-busy)
and after memory clear, restore them to OFF.
DESCRIPTION DATA
Clear all memory for CMDC and CMDB. •
(1)
(2)
Y=90 All memory clear
0000
CCC
DESCRIPTION DATA
Clear the memory for the calling number
Development Table number assigned by
CMDC and the calling number develop-
ment data assigned by CMDB.
•
(1)
(2)
Y=91 Partial memory clear
0001
CCC
Clear the memory for calling number de-
velopment data assigned by CMDB.
•
(1)
(2)
Y=92 Partial memory clear
0002
CCC
START
END
CMDB
START
END
CMDB