FEATURES FOR OTHER COUNTRIES ONLY
CALLER ID CLASS
– 598 –
A2594-10
(4) CALLER ID Development Data Assignment
DESCRIPTION DATA
Assign the Development Table for the call-
ing number sent from the network.
•
(1)
(2)
Y=00-63 Trunk tenant No.
Calling No.
0 -1499: Development Table No.
0-1499
Assign whether the trunk tenant number is
effective for developing the calling number,
or not.
•
(1)
(2)
Y=30
0: Trunk tenant No. development
0 : Ignore actual trunk tenant and use
the Development Table for trunk
tenant 00 (CMDC Y=00)
1 : Execute actual trunk tenant and
use the Development Table for
each trunk tenant (CMDC Y=00-
63)
By character code, assign the name dis-
played, if required.
A maximum of 14 characters are available
for the name display.
•
(1)
(2)
Y=00 Name Assignment
0-1499: Development Table No.
Character code (See APPENDIX B:
CHARACTER CODE TABLE.)
Assign the termination destination on Day
Mode/Night Mode for calling number, if re-
quired. A maximum of 12 digits are avail-
able.
•
•
(1)
(2)
Y=01 Day Mode
Y=02 Night Mode
0-1499: Development Table No.
Destination station No. (Max. 12 digits)
NOTE: If assigning the destination station number as below, the terminating system over
rides CM30 Y=02/03 for the selected Development Table.
* * * * 0 2: Trunk Line Appearance
* * * * 0 3: Trunk Line Appearance + TAS
* * * * 0 4: Direct-in Termination
* * * * 0 9: Automated Attendant
* * * * 1 0: Attendant Console + TAS
* * * * 1 1: Attendant Console + Trunk Line Appearance
* * * * 1 2: Attendant Console + Trunk Line Appearance + TAS
* * * * 1 4: Termination to Attendant Console
* * * * 1 6: Remote Access to System
* * * * 3 1: DID, TIE, and any call which is not handled by the PBX
NOTE: The destination station number can also be an LCR access code plus outside tele-
phone number.
CMDB
START
CMDC
A
To Next Page
Loading...
