’Job Attributes’ Section Print Job Manager
252 A29247-X3-X-6-7670
‘Form’ In this field you can enter or select a specific ‘form’ (size and appearence of the
logical page) which will be assigned to the whole printjob. In the ’Job list’ window
the selected form will be displayed giving you the possibility to print only jobs of
the same form. You define the forms available in the PJM with the ’Paper’ tool to
be selected from the Explorer tree view.
If the SCT tool is used for LCDS jobs, the table name of the active SCT table is
used as 'form' entry. In this case the PJM 'form' entry in not used.
‘Input tray’ The selection provided here depends on the definition of input tray names you
make under Configuration -> Printer -> Input Devices. The input tray of the printer
itself has to be set to ‘Remote’.
Default: Information on the input trays is read from the data stream.
Printer Default: The information comes from the configuration of the printer.
‘Output tray’ The selection provided here depends on the definition of output tray names you
make under Configuration -> Printer -> Output Devices. The output tray of the
printer itself has to be set to ‘Remote’.
To work with the settings of the ’UP3I Devices’, you have to activate the UP3I-
tray, you configurerd in the printer configuration (see below).
Default: Information on the input trays is read from the data stream.
Printer Default: The information comes from the configuration of the printer.
’Toner Colors’ The button(s) in this section allow you to configure one or two toner stations to
print a custom tone. For details see workflow description below.
To Next Page
Loading...
