Print Job Manager ’Job Attributes’ Section
A29247-X3-X-6-7670 253
‘Print Mode’ These parameters enable you to set the hardware mode on the printer. The ‘Print
mode’ defines the relation between logical pages and the physical page when
printing on a fanfold printer.
You can enter any mode, even if there is a different one selected for the Com-
poser. However, when you use the hardware mode, the settings for this mode will
be executed in addition to the mode settings specified in the Composer.
Example: If you have selected ‘Two up’ mode in the Composer and ‘Identical
copies’ for the hardware mode, the document will first be processed for two-up
and then an identical copy will be made of this two-up.
Example: If you select the default ‘No Two up’, the document will just be manip-
ulated by the 'Two-up' of the Composer.
Normal
One logical page will be printed on the physical page.
Two up
The logical pages 1 and 2 will be printed on the first physical page, pages 3 and
4 on the second physical page.
Identical copies
The logical page 1 and it’s copy (copies) will be printed on the first physical page,
logical page 2 and it’s copy (copies) will be printed on the second physical page.
Invers Two up
The logical pages 2 and 1 will be printed on the first physical page, pages 4 and
3 on the second physical page.
Default
Uses the hardware mode which is set on the printer itself.
Printer Default
The information comes from the configuration of the printer.
To Next Page
Loading...
