Printer Administrator Command Line Interface
314 A29247-X2-X-8-7670
spladmin -p XXX npro value Sets the NPRO interval for printer XXX.
Permitted values: 0 – 43200 seconds (=12h)
spladmin -p XXX auto-
mode
on
off
Enables the automatic starting and stopping of a
printer if a job becomes printable.
Default = off
spladmin -p XXX form Form Id Set the next form id to use for "Check Form" and
"Formsequencing"
spladmin -p XXX check-
form
on
on,seq
off
Enables the automatic preference of a job with the
same form.
"on.seq" enables checking form name and switching
to a new form, if no job with the specified form are
longer available.
Default = off
spladmin -p XXX check-
res
on
off
Enables checking of the resolution specified with a
submitted job.
Default = on
spladmin -p XXX check-
prn
on
off
Enables checking of the destination printer specified
with a submitted job.
Default = on
spladmin -p XXX check-
cls
on
off
Enables checking of the job queue specified with a
submitted job.
Default = on
Call Display and Explanation
To Next Page
Loading...
