Oki MC860 - REPORTS AND LISTINGS

43967002TH Rev.1
111 /
Oki Data CONFIDENTIAL
3. Installation
Item Contents
Network IPv6 Address (local) xxxx:xxxx:
xxxx:xxxx:
xxxx:xxxx
Th is me n u i s not i n di c ate d w hen
[Administrator Setup] - [Network control] -
[Network Setup] - [TCP/IP] is invalid, or if [IP
version] is “IPv4”.
IPv6 Address (global) xxxx:xxxx:
xxxx:xxxx:
xxxx:xxxx
Th is me n u i s not i n di c ate d w hen
[Administrator Setup] - [Network control] -
[Network Setup] - [TCP/IP] is invalid, or if [IP
version] is “IPv4”.
When [Admin Setup] is pressed
Note! The [Admin password] is required to enter this menu.
By default, Administrator password is not set.
Copy Setup
The shaded portion shows the default setup value when shipped from the factory.
Item Contents
Default
Settings
Doc.Type Doc.Type Text
Text/Photo
Photo
Extra Fine
Set default setup of image quality.
Removal for
Background
& Show-
Through
(sTHR)
Auto
OFF
1
2
3
4
5
sTHR
Set default setup of background/offset
phenomenon removal.
The shaded portion shows the default setup value when shipped from the factory.
Item Contents
Default
Settings
Density -3
-2
-1
0
+1
+2
+3
Set default setup of density.
Zoom 100%
Automatic
Set default setup of Enlarge/Reduce.
Sort OFF
ON
Set default setup to sort copied sheets in the
order of page number.
Select the default setup whether documents
of different sizes are copied to the papers of
different sizes or not.
Margin Margin OFF
ON
Set default setup of Enable/Disable binding
margin.
Left (Front) 0~±25mm
(1mm step)
0
0~±1.0inch
(0.1inch step)
Set default setup of distance of movement of
copied output image toward right on the front
side of copy paper.
(Display in units of mm or display in units of
inch can be switched by changing the unit of
display on the system setup).
Top (Front) 0~±25mm
(1mm step)
0
0~±1.0inch
(0.1inch step)
Set default setup of distance of movement of
copied output image toward bottom on the
front side of copy paper.
(Display in units of mm or display in units of
inch can be switched by changing the unit of
display on the system setup).
Left (Back) 0~±25mm
(1mm step)
0
0~±1.0inch
(0.1inch step)
Set default setup of distance of movement of
copied output image toward right on the back
side of copy paper.
(Display in units of mm or display in units of
inch can be switched by changing the unit of
display on the system setup).
Top (Back) 0~±25mm
(1mm step)
0
0~±1.0inch
(0.1inch step)
Set default setup of distance of movement of
copied output image toward bottom on the rear
side of copy paper.
(Display in units of mm or display in units of
inch can be switched by changing the unit of
display on the system setup).