Oki MC860 - NETWORK SET UP

43967002TH Rev.1
28 /
Oki Data CONFIDENTIAL
1. Configuration
1.5 Interface specifications
2
3 4
1
1.5.1 USB interface specifications
Fundamental specifications
USB(Hi-speed USB is supported)
Connector
B-receptacle (female) upstream port
Cable
SUB 2.0 specification cable of less than 5 m (2 m is recommended.)
(Use the shielded cable.)
Transmission mode
Full speed (Maximum 12 Mbps ± 0.25%)
High speed (Maximum 480 Mbps ± 0.05%)
Power control
Self-power device
Connector pin arrangement
1.5.2 Network interface specifications
Fundamental specifications
Network protocol
TCP/IP related
NetWare related
Ether Talk related
NetBEUI related
Connector
100 BASE-TX/10.BASE-T (Automatic switching. Simultaneous use is not possible.)
Cable
Non-shielded twist pair cable with RJ-45 connector (Category 5 is recommended.)
Connector pin arrangement
Interface signal
Pin No. Signal name Direction Function
1 TxD+ FROM PRINTER
Send data (+)
2 TxD- FROM PRINTER
Send data (-)
3 RXD+ TO PRINTER
Receive data (+)
4 − −
Not used
5 − −
Not used
6 RXD- TO PRINTER
Receive data (-)
7 − −
Not used
8 − −
Not used
Interface signal
Signal name Function
1 Vbus
Power (+5V)
2 D-
For data transfer
3 D+
For data transfer
4 GND
Signal ground
Shell Shield
81