43967002TH Rev.1
237 /
Oki Data CONFIDENTIAL
5. Maintenance Menu
5.10.2 Peak Power Control
Value Default Display condition
Normal
Low
Normal None
Set whether or not to support the low peak power control . When the screen exits the service
menu after this setting is changed, the MFP reboots automatically.
5.10.3 Engine Diag Mode (Self-diagnostic)
Screen enters the engine maintenance mode of MFP.
The information to be displayed on this screen after this item has been selected, is created
by the CU side.
Key operation information on panel is notified from CU so that the display information is
created based on the received information and is sent to the panel.
Panel displays the received display information
Self-diagnostic
mode layout (entire)
(1) Entering into the menu item.
Moving to another level is possible only when the
level is displaying the XXXXX message.
Moving to XXXXX is executed by pressing the (2) key
or (8) key.
XXXXX
XXXXX
LEVEL 0 – Engine status display
Engine status display
(Heater temperature)
(Environmental temperature and
humidity display)
Setup table
Transfer voltage
Transfer OFF voltage, belt
temperature
Error details
LEVEL1-ENGINE DIAG MODE XX.XX
SWITCH SCAN
MOTOR & CLUTCH TEST
TEST PRINT
REG ADJUST TEST
DENS ADJ TEST 2
CONSUMABLE STATUS
PRINTER STATUS
FACTORY MODE SET
SENSOR SETTING
LED HEAD DATA
Service menu
Press the (6) key.
Select the menus: [Printer Maintenance]
[Engine
Diag Mode].
* For the method of entering the Service mode, refer
to item 5.1.
5.10.3.1 Operator panel
Operation description on the self-diagnostic is displayed on the premise that the control panel
has been arranged as described below.
Press the (4) key.
Press the (6) key.
Press the (6) key.
To Next Page
Loading...
Need help?
Printing Specifications
Weight and Dimensions
