d-Color MF552/452/362/282/222 15-191
15
[Address Reg.] ([Annotation]) ([Send])
To display: [Box] - [System] - [Annotation] - Select a User Box - [Open] - Select the file - [Send] - [Direct
Input] - Enter Destination - [Address Reg.]
You can register the destination that you have entered directly into the address book. For details on how to
register it, refer to [User's Guide: Scan Operations].
[Resolution] ([Annotation]) ([Send])
To display: [Box] - [System] - [Annotation] - Select a User Box - [Open] - Select the file - [Send] - [Resolution]
Select a resolution level to use to send files.
Tips
- If the resolution is high, a large amount of information is scanned and the transmission time increases.
When you are using the E-mail TX, make sure that the data capacity is not restricted.
Settings Description
[Scan Resolution] Select the resolution to be used for scanning and sending of the original.
To use E-mail TX, SMB TX, FTP TX, or WebDAV TX, the following resolution
is selected for sending.
• [Settings when saving]: Select this option to send the document in the
same resolution as used for saving.
• [200 e 200 dpi]: Select this option to send the document in the standard
resolution.
• [300 e 300 dpi]: Select this option to send the document in a higher res-
olution than the normal resolution.
• [400 e 400 dpi]: Select this option to send the document containing
small characters and drawings.
• [600 e 600 dpi]: Select this option to convert the original to a file of the
largest possible size. Use this option to scan a file such as a full color
photo to have a fine image quality level.
To Next Page
Loading...
Need help?
General
