WWW.NNC.IR
19
Vision System FH/FZ5 Series
User’s Manual (Z340)
● Maintenance
• Turn OFF the power and take safety precautions before conducting inspections. Electrical shock can result
from attempting safety inspections with the power turned ON.
• Clean the lens with a lens-cleaning cloth or air brush.
• Lightly wipe off dirt with a soft cloth.
• Dirt on the CCD must be removed using an air brush.
• Do not use thinners or benzene.
● Communication with High-order Device
• After confirming that this product is started up, communicate with the high-order device. When this product
has started up, an indefinite signal may be output from the high-order interface. To avoid this problem,
clear the receiving buffer of your device at initial operations.
● Fail-Safe Measures
• If you wish to operate a stage and/or a robot using a measurement result from a sensor controller(e.g. axis
movement amount output based on calibration/alignment measurement),always take safety measures so
that the measurement result should be checked by the stage/robot if it is within the range of movement of
the stage/robot before operation.
• On a sensor controller side, supplementarily use operations and branches of the sensor controller to
configure a check flow such as “data should not be externally provided if the data is in a range from
-XXXXX to XXXXX “ based on the stage/robot’s range of movement.
To Next Page
Loading...
Need help?
General
