WWW.NNC.IR
Setting the Camera Conditions
264
Vision System FH/FZ5 Series
User’s Manual (Z340)
Setting the Camera Conditions
Checking the Camera Connections: [Camera Connection]
You can check whether a Camera is connected. There are no settings.
1 In the Main Window, select [System settings] − [Camera] − [Camera Connection] from the
[Tool] menu.
The Camera Connection Settings View is displayed.
2 Check the connection status.
If a Camera is connected, the model name of the
connected Camera will appear next to the Camera
number.
If the [Disconnect] is displayed even though a
Camera is connected, there could be a failure or a
disconnected line. Check the physical connection.
3 Click the [Close] Button.
Setting the Trigger Delay: [Inter-camera setting]
This setting is used to set the delay time from when the STEP signal for the input trigger is received to when the
shutter is triggered. You can use this to prevent mutual interference caused by the lighting when more than one
Camera is used, or as a simple trigger delay when only one Camera is used.
Set the STGOUT pulse width in the [Electronic flash setting] under the [Camera Image Input] processing item.
Reference: Electronic Flash Setting of the Vision System FH/FZ5 Series Processing Item Function Reference Manual
(Cat No. Z341).
STEP
ON
OFF
ON
OFF
Camera 0
shutter trigger
ON
OFF
Camera 1
shutter trigger
STEP - camera 1 delay
STEP - camera 0 delay
ON
OFF
STGOUT0
ON
OFF
STGOUT1
STEP - STGOUT1 delay
STEP - STGOUT1 delay
STGOUT0 width
STGOUT1 width
To Next Page
Loading...
Need help?
General
