Omron SYSMAC FH Series User Manual

WWW.NNC.IR
Saving Data to the FH/FZ5
254
Vision System FH/FZ5 Series
User’s Manual (Z340)
Saving Data to the FH/FZ5
This section describes how to save and load setting data and logged image data.
About Saving Areas
The following saving areas can be used with the Sensor Controller.
Saving area Description Save operation
Controller
Flash memory
in the
Controller
The settings data (system data, scene data, and scene group data)
is saved to this area when you click the [Data save] button. Data is
held even after the power supply is turned OFF. When you restart
the Controller, the Controller loads and enables the settings data in
the flash memory.
[Function] − [Data
save] or the [Data
save] button
Controller
memory
(RAM)
This is the area where images are temporarily stored when logging
images using the logging function. This memory is a ring memory.
Images will be overwritten starting with the oldest image if the
maximum number of save images is exceeded.
[Function] − [Save to
file] or [Function] −
[Screen capture]
RAM disk in
the Controller
You can use this memory as a temporary file save destination.
The data is cleared when you turn OFF the power supply to the
Controller. As this is memory inside the Controller, files can be
saved and read faster than when using external memory. The FH or
FZ5-11 has 256 MB, and the FZ5-L3 has 40 MB. The
capacity cannot be changed. The RAM disk data can be sent to or
received from external devices using FTP.
External
memory
USB memory
This memory is used to back up setting data as a precaution, to
copy setting data to another Controller, and to load data to a
computer.
SD memory
card (FH only)
Shared folder
on a computer
connected to
the network

Omron SYSMAC FH Series Specifications

General

Brand	Omron
Model	SYSMAC FH Series
Category	Industrial Equipment
Language	English