Omron SYSMAC FH Series User Manual

WWW.NNC.IR
Loading Settings Data from the Controller RAM Disk or
an External Memory Device to the Sensor Controller
261
6
Saving and Loading Data
Vision System FH/FZ5 Series
User’s Manual (Z340)
Loading Settings Data from the Controller RAM Disk or an External Memory Device to the Sensor Controller
Use the following procedure to load settings data that is saved in the Controller RAM disk or an external memory
device to the Sensor Controller The scene name and scene group name that have been loaded are displayed in
the Measurement Information Display Area.
1 Perform either of the following in advance.
Send the setting data to the Controller’s RAM disk using the FTP.
Insert the external memory device that has the load data saved in it into the Controller.
2 In the Main Window, select [Load from
file] from the [Function] menu.
The [Load from file] dialog box is displayed.
3 Select the file to load.
4 Click [OK].
A dialog box that shows the progress of the transfer is displayed, and the data is transferred.
The loaded settings are enabled after the Sensor Controller is restarted.
5 Select [System restart] from the [Function] menu.
• Always restart the Sensor Controller immediately after you load the settings data.
• If [Load from file] is performed for [System + scene group 0 data], the data being loaded will also be saved to the
Controller’s flash memory at the same time. While data is being loaded, do not restart, turn OFF the power supply, or
remove the external memory device. Data will be corrupted and the system will not work properly at the next startup.
IMPORTANT

Omron SYSMAC FH Series Specifications

General

Brand	Omron
Model	SYSMAC FH Series
Category	Industrial Equipment
Language	English