WWW.NNC.IR
Executing Test Measurements
74
Vision System FH/FZ5 Series
User’s Manual (Z340)
Executing Test Measurements
Test whether the intended measurement processing can be performed with the current setting contents. Look at
test results and adjust the property settings of each processing unit.
Perform measurement according to the conditions set for the displayed scene.
1 In the Main Window (layout 0), click the [Camera image meas.] button in the Measurement
Pane.
2 Set the following items as test
conditions.
3 Click the [Measure] button in the Measurement Pane.
The measurement is performed.
4 Check the measurement results.
5 If necessary, adjust the setting values
for each processing unit again.
You can move to the property dialog box
directly by clicking the button of any
processing unit in the flow.
Parameter Description
Output
Select this check box when the measurement results on the adjustment window are also
to be output. Clear the checkmark when test measurement for the device is to be
performed without results being output.
Continuous meas.
Select this check box when continuous measurement is to be performed.
Click the [Measure] button to start continuous measurements.
• If continuous measurements are in progress, the [Stop continuous meas.] button will be displayed. To stop
continuous measurements, click the [Stop continuous meas.] button.
Test images can be saved. This function is called logging. After setting conditions, the saved test images can be used in
performing test measurements again.
Reference: Logging Measurement Values and Measurement Images (p.113)
The measurement interval and display update interval will vary for continuous measurements with test measurement
settings and continuous measurements with serial commands or parallel commands.
Evaluate the measurement interval and display update interval by watching actual operation.
Note
Property setting buttons
To Next Page
Loading...
Need help?
General
