Omron SYSMAC FH Series

WWW.NNC.IR
Setting the Operating Environment of the System
291
7
Changing the System Environment
Vision System FH/FZ5 Series
User’s Manual (Z340)
Setting the Operating Environment of the System
This section describes how to set the operating environment of the Controller. The following settings are
available.
• Reference: Setting the Date and Time: [Date-time Setting] (p.291)
• Reference: Selecting the Language: [Language Setting] (p.292)
• Reference: Setting the Fan Rotation Speed: [Fan Control Setting] (p.292)
• Reference: Setting the Status at Startup: [Startup Settings] (p.293)
• Reference: Setting the Encoder Trigger: [Encoder Trigger Setting] (p.296)
• Reference: Setting the STEP Input Detection Pulse Width: [STEP Setting] (p.297)
• Reference: Setting a Network Drive: [Network Drive Setting] (p.298)
• Reference: Setting Up a Connection to the External Device
This section describes communications with external devices, such as computers and
programmable controllers.
Refer to the Vision System FH/FZ5 Series User's Manual for Communications Settings (Cat No.
Z342) for details.
The Controller model and measurement application version can also be checked.
• Reference: Checking System Information: [System Information] (p.300)
Setting the Date and Time: [Date-time Setting]
Confirm that the date and time on the built-in calendar are correct, and make corrections if they are not.
The log data dates and times are set based on contents set here.
1 In the Main Window, select [System settings] − [Other] − [Date-time setting] from the [Tool]
menu.
The [Date-time setting] dialog box is displayed.
2 Set the current date and time.
3 Click the [Apply] button.
Close the [Date-time setting] dialog box.