WWW.NNC.IR
Macro Reference
415
8
Appendices
Vision System FH/FZ5 Series
User’s Manual (Z340)
AssignUnit
Registers the processing unit.
Format
AssignUnit <unitNo>, <itemIdent>
Parameter
Return value
None.
Description
Registers the processing item with the identification name specified in the <itemIdent> parameter as a
processing unit in the position in the measurement flow specified in the <unitNo> parameter.
If a processing unit is already registered in the position specified in the <unitNo> parameter, that processing
unit is overwritten.
If an incorrect data type is specified for a parameter, a "Type mismatch" error will occur.
If a non-existent number, numerical value, or combination of data types or values is specified for a parameter,
an "Illegal function call" error will occur.
If an identification name that does not exist is specified as the <itemIdent> parameter, an "Illegal function call"
error will occur.
If the format is written incorrectly, such as writing the macro function name incorrectly, omitting a comma, or
omitting a half-width space, a "Syntax error" error will occur.
Usage Cautions
• Execute this macro function when the BUSY signal or other measurement in progress signal is ON and
measurement is prohibited. (Reference: XState Transitions and Execution Timing (p.227))
Example
Registers the search processing unit at the end of the measurement flow.
Useable Modules
Scene Control Macro / Communication Command Macro
Supported Versions
Version 3.50 or later
Parameter
name
Data type Description
<unitNo> Integer type
Processing unit number on the measurement flow to register the processing unit (0 to
the enrollment number of the processing units at the current scene)
<itemIdent>
Character
string type
Identification name of the processing item to register as a processing unit
Rem Get the number of processing units registered in the current measurement flow.
UNUM& = UnitCount
Rem Add the search processing unit.
AssignUnit UNUM&, "Search"
To Next Page
Loading...
Need help?
General
