List of figures
108580_en_02 PHOENIX CONTACT 259 / 272
Figure 6-3: PLCnext Engineer safety prompt: switching to debug mode .............158
Figure 6-4: SPNS state: Debug Run ...................................................................159
Figure 6-5: SPNS state: Debug Stop .................................................................. 159
Figure 6-6: After successful firmware update, the RFC runs without any errors .. 160
Section 7
Figure 7-1: “FACTORY RESET” menu ................................................................ 163
Figure 7-2: Default settings of the RFC 4072S: indication on the display ............ 163
Figure 7-3: “CONFIG DETAILS, … EDIT LAN2” menu: default settings .............. 165
Figure 7-4: “CONFIG DETAILS, … EDIT LAN2” menu:
edit LAN2 IP address ........................................................................ 165
Figure 7-5: “CONFIG DETAILS, … EDIT LAN2” menu: LAN2 IP address ...........166
Figure 7-6: “CONFIG DETAILS, … EDIT LAN2” menu:
LAN2 IP settings changed ................................................................ 166
Figure 7-7: “CONFIG DETAILS” menu: nothing has been changed .................... 166
Figure 7-8: Logging into the RFC 4072S via WinSCP .........................................167
Figure 7-9: PLCnext directory “/opt/plcnext” in the parameterization memory. .... 168
Figure 7-10: Realtime clock settings for the RFC 4072S ....................................... 168
Figure 7-11: PROFINET device – “Start AR on startup” ........................................169
Figure 7-12: PROFINET device – “Substitute value behavior of inputs” ................ 171
Figure 7-13: AR_MGT function block ....................................................................174
Section 8
Figure 8-1: System variables grouped into structures .........................................175
Section 9
Figure 9-1: RFC 4072S welcome page ............................................................... 196
Figure 9-2: “Licenses and Legal Information” link ............................................... 198
Figure 9-3: WBM user interface: selecting the language .....................................199
Figure 9-4: WBM: Login page .............................................................................200
Figure 9-5: WBM start page ................................................................................ 201
Figure 9-6: WBM: “General Data” page .............................................................. 202
Figure 9-7: WBM: “Firmware Update” page ........................................................ 203
Figure 9-8: WBM: “PROFINET Diagnostics – Overview” page ............................204
Figure 9-9: WBM: “PROFINET Diagnostics – Device List” page .........................205
Figure 9-10: WBM: “User Authentication” page ....................................................206
Figure 9-11: WBM: “Enable/Disable User Authentication” dialog ..........................207
To Next Page
Loading...
Need help?
General
