6
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
6.13
GEAR CLUSTER DISASSEMBLY
1. Remove the bearing from the reverse shaft using a
bearing puller. Remove the retaining ring and slide
the washers, high gear and needle bearing off the
reverse shaft.
q
Park/Low Shift Dog
y
Needle Bearing
w
Thrust Washer
u
Reverse/High Shift
Dog
e
Low Gear
i
Snap Ring
r
Reverse Shaft
o
High Gear
t
Reverse Gear
a
Bearing
2. Remove the Reverse/High shift dog.
3. Remove the snap ring, washer, needle bearing, and
reverse gear from the reverse shaft.
4. If necessary, disassemble the other end of the
reverse shaft. Remove the bearing , Park/Low shift
dog, retaining ring, washer, low gear and needle
bearing from the reverse shaft.
SNORKEL TUBE REMOVAL / DISASSEMBLY
CAUTION
The pinion shaft must be removed prior to removing the
snorkel tube assembly. Failure to remove pinion shaft
will result in damage to the snorkel tube or LH
gearcase.
1. Using the Snorkel Tube Tool and two of the coupler
bolts to hold the coupler, remove the front output
shaft coupler nut
q
and washers
w
.
Snorkel Tube Tool:
PU-51862
2. Use the snorkel tube tool to remove the snorkel tube
and front output shaft as an assembly.
TRANSMISSION
To Next Page
Loading...
Need help?
General
